Lockitall LOCKIT PRO r d.01 ______________________________________________________________________ User Manual: Lockitall LockIT Pro, rev d.01 ______________________________________________________________________ OVERVIEW - This lock contains the all-new LockIT Pro Account Manager. DETAILS The LockIT Pro d.01 is the first of a new series of locks. It is controlled by a MSP430 microcontroller, and is the most advanced MCU-controlled lock available on the market. The MSP430 is a very low-power device which allows the LockIT Pro to run in almost any environment. The LockIT Pro contains a Bluetooth chip allowing it to communiciate with the LockIT Pro App, allowing the LockIT Pro to be inaccessable from the exterior of the building. LockIT Pro Account Manager solves the problem of sharing passwords when multiple users must have access to a lock. The Account Manager contains a mapping of users to PINs, each of which is 4 digits. The system supports hundreds of users, each configured with his or her own PIN, without degrading the performance of the manager. There are no accounts set up on the LockIT Pro Account Manager by default. An administrator must first initialize the lock with user accounts and their PINs. User accounts are by default not authorized for access, but can be authorized by attaching the Account Manager Authorizer. This prevents users from adding themselves to the lock during its use. This is Hardware Version D. It contains the Bluetooth connector built in, and one available port, to which the LockIT Pro Deadbolt should be connected. When authorizing PINs, the Deadbolt should be disconnected and the Authorizer should be attached in its place. This is Software Revision 01. It is a much more advanced version of other locks, but the first Version D release. (c) 2013 LOCKITALL Page 1/1