Lockitall LOCKIT PRO r c.04 ______________________________________________________________________ User Manual: Lockitall LockIT Pro, rev c.04 ______________________________________________________________________ OVERVIEW - Passwords may now only contain alphanumeric characters. - This lock is attached the the LockIT Pro HSM-2. DETAILS The LockIT Pro c.04 is the first of a new series of locks. It is controlled by a MSP430 microcontroller, and is the most advanced MCU-controlled lock available on the market. The MSP430 is a very low-power device which allows the LockIT Pro to run in almost any environment. The LockIT Pro contains a Bluetooth chip allowing it to communiciate with the LockIT Pro App, allowing the LockIT Pro to be inaccessable from the exterior of the building. There is no default password on the LockIT Pro HSM-2. Upon receiving the LockIT Pro, a new password must be set by first connecting the LockitPRO HSM to output port two, connecting it to the LockIT Pro App, and entering a new password when prompted, and then restarting the LockIT Pro using the red button on the back. LockIT Pro Hardware Security Module 2 stores the login password, ensuring users can not access the password through other means. The LockIT Pro can send the LockIT Pro HSM-2 a password, and the HSM will directly send the correct unlock message to the LockIT Pro Deadbolt if the password is correct, otherwise no action is taken. This is Hardware Version C. It contains the Bluetooth connector built in, and two available ports: the LockIT Pro Deadbolt should be connected to port 1, and the LockIT Pro HSM-2 should be connected to port 2. This is Software Revision 04. Due to user confusion over which characters passwords may contain, only alphanumeric passwords are accepted. (c) 2013 LOCKITALL Page 1/1